Are you looking for an easy way to update your Braeburn thermostat? If so, you have come to the right place! Replacing the battery on your Braeburn thermostat is a great way to keep it running efficiently and save money on utility bills.
In this blog post, I’ll provide step-by-step instructions on how to replace the battery in your Braeburn thermostat quickly and easily.
When Should You Replace Batteries of Your Braeburn Thermostat?
If your thermostat displays a low battery indicator, it is time to replace the batteries. Most models of Braeburn thermostats use two 3V lithium-ion batteries. The average life of a battery is 3-5 years, so it is recommended to replace the batteries every five years.
Keep in mind that you should use good batteries. However, like any battery, they will eventually need to be replaced. Follow these tips to ensure you get the best quality batteries for your thermostat:
How Do I Change The Battery In My Braeburn Thermostat?
#Step 1: Locate the Battery Compartment:
Normally the battery compartment is located on the right/back side of the thermostat, so find them out.
Next, remove the cover by pressing down the two tabs on the front and pulling it off. Inside, you will see 4 screws that need to be removed to remove the battery (If your thermostat has screws, otherwise not).
#Step 2: Remove the Old Battery:
Now, you’ll need to remove the old battery. To do this, first, remove the old batteries from the battery compartment carefully. If you cannot remove it, you can use a screwdriver or electric tester to get help.
#Step 3: Insert the New Battery:
Replace the thermostat battery with a new one. Again, be sure to discard the old battery and push the new battery down until it clicks into place.
#Step 4: Close the Battery Compartment:
When you are finished replacing the battery in your thermostat, you will need to close the battery compartment.
To do this, first, cover up the thermostat battery with a compartment cover. Next, screw them in until they are tight. Then, use the Allen wrench that came with the thermostat to tighten them up another 1/4 turn.
FAQs
If your Braeburn 1020NC thermostat is not working, it may be because of a dead battery. This guide will show you how to replace the batteries in your Braeburn 1020NC thermostat. So try the above steps to replace your battery.
If the thermostat battery is low, the heating and cooling system will not work as intended. Also, the system will turn on and off automatically.
To check if your thermostat runs batteries, first remove the cover from the unit. If the batteries are visible, then your thermostat is using batteries.
Yes, most thermostats run without batteries. In some cases, the AC power source has been used in thermostats that work without battery power.
One common issue is that the battery may not be holding a charge, so it may not be able to communicate with the thermostat. So that, it may not be able to control the temperature. Also, if the power to the thermostat is interrupted, it may not be able to operate.
At the end of the guide, changing the battery on your Braeburn thermostat is a quick and easy process. However, before replacing your old battery, it is essential to note that your thermostat may still work. If the old battery is less than a year old, likely, the thermostat will still work. We hope this guide has helped you replace the battery in your Braeburn thermostat.
